V8 cockpit.  Can be used on / with other frames / stems (of course).
 
Slightly wider stem clamping area than the 'usual' PDQ tt bars to allow a wider choice of aero stems. Gap on these is 44 mm front and 47 mm rear.
 
Base bar is pre-drilled to accommodate brake cable entry and exit (directly into stem ... CHECK YOUR STEM WILL BE COMPATIBLE ... or be prepared to drill your own holes on underside of base bar).
 
Clamps are designed to allow a (small) element of tilt to both the rests and extensions without the need for angled clamps (Pukka for example).
 
Risers and clamps are NOT compatible with other PDQ bars as the spacing for the fixing bolts on these are 30 mm c/c as opposed to the 25 mm used on the usual design.
 
Standard dia clamps (so the likes of PDQ Top Trump extensions WILL fit).
 
Base bars measure 42 c/c
 
Total weight of everything shown in photo = approx 827 gms
 
Long extensions measuring 36.5 cms end to end (4 cms longer than original design)